Daily Cleanning / End Of Work - Adler DWA2050 Guide Rapide

3D – DAILY CLEANNING / END OF
WORK
In order to have excellent washing results and a
cleaned tank, it is recommended to change the
water of the machine at least twice a day and
clean accurately all the filters inside the tank.
Filters must be removed only once all the water
is drained out of the machine.
3D1 – WATER DRAIN (
MECHANICAL MACHINE
WITHOUT DRAIN PUMP
1- Turn OFF the machine by pressing button "A"
On/Off.
2- Open the door and remove the water flow
device. (Fig.38)
Fig.38
3- Wait until all the water is completely drained
out from the tank.
3D2 – WATER DRAIN (
ELECTRONIC MACHINE
WITH DRAIN PUMP
1- Turn OFF the machine by pressing button "A"
On/Off.
2- Open the door and remove the water flow
device. (Fig.39)
Fig.39
3- Hold button "G" drain water until it starts
drain process. (Fig.40)
G
Fig.40
4- Wait until all the water is completely drained
out from the tank. The machine will turn OFF
automatically after completing drain process.
3D3 – WATER DRAIN (
MECHANICAL MACHINE
WITH DRAIN PUMP
1- Open the door and remove the water flow
device. (Fig.41)
Fig.41
2- Hold button "I" drain water for the entire
Fig.42
3- Turn OFF the machine by pressing
)
1- Turn OFF the machine by pressing
2- Manually remove side or central filters or
Fig.43
3- Wash and clean filters accurately on
4- Repositionated
)
3D5 – EXTERNAL SURFACES CLEANNING
Before
operations, turn off the power at the mains.
To reduce the emmission of pollutants into
the
(externally and where necessary internally)
with products having a biodegradability of
over 90%.
CLEAN STAINLESS STEEL SURFACES BY
USING WARM SOAPY WATER; NEVER USE
DETERGENT
SUBSTANCES
COMMON WIRE WOOL, BRUSHES OR
SCRAPES; RINSE THOROUGHLY USING A
WET CLOTH AND CAREFULLY WIPE DRY.
DO NOT WASH THE APPLIANCE BY USING
DIRECT OR HIGH PRESSURE WATER JETS.
)
1- Drain out completely the water from the
2- Turn OFF the machine by pressing
3- Close the door and turn off the power at
time necessary to drain out completely
the water from the tank. (Fig.42)
G
button "A" On/Off.
3D4 – FILTERS CLEANNING
button "A" On/Off.
by unscrewing the ferrule located on the
top rounded filter inside the tank. (Fig.43)
running fresh water.
all
components inside the machine.
carrying out any
enviroment, clean the
WARNING!
CONTAINING
NOR STEEL
3D6 – TURNING OFF THE MACHINE
tank. (see par.3D1/2/3)
button "A" On/Off.
the mains.
filters and
cleanning
appliance
ABRASIVE
SCRAPERS,
19