Detergent And Rinse Aid Dispensers And Settings - Adler DWA2050 Guide Rapide

2D - DETERGENT AND RINSE AID
DISPENSERS AND SETTINGS
Before starting a new cycle the dispenser and its
pipe must be completely filled. Check the level of
the detergent or rinse aid and eventually fill-up
the tank.
N.B.
The level in the detergent or rinse aid tank
must not get empty or filled with corrosive or
inadequate products. The warranty does not
cover damages caused by improper use of
dispenser. The dispenser is calibrated at
manufacturer site: dispenser settings after
installation can be performed only by
qualified specialists.
1- Extract the front panel with Allen tool or
similar by inserting it inside the holes on the
inferior part of the panel. Pull up the panel
carefully. For Hoodtype models, unscrew the
two screws located on the bottom of the
panel. (Fig.8)
Fig.8
Before removing the front panel make sure the
machine is disconnected from the main breaker.
2- Insert included dispenser
detergent or rinse aid tank. (if available). (Fig.9)
Fig.9
2D1 – PRESSURE RINSE AID DISPENSER
Setting of rinse aid dispenser is perfomed acting
on the screw accessible after removal of front
panel, under the tank door. (see Fig.8)
1- Close gently all the way down the dispenser
by screwing anticlockwise the needle valve
of the dispenser.
2- Open up until reached necessary quantity by
screwing clockwise the needle valve of the
dispenser. (Fig.10)
Fig.10
Quantity for the first setting should be
according
evaluating the hardness of the water and
the type of rinse aid used. Recommended
vacum standard quantity of rinse aid from
the included tube 4 x 6 correspond to
approximately 4 cm = 0,5cc = 0,5 gr. for
each 50 x 50 standard rack machine.
Otherwise, approximately 2,5 cm = 0,3 =
0,3 gr. for 35 x 35 and 40 x40 standard
rack
permit is approximately 25,8 cm = 3,6 cc =
3,6 gr.
After first setting rinse aid dosage must be
optimize by evaluating washing results after
few cycles.
2D2 – PERISTALTIC RINSE AID AND
Setting of rinse aid dispenser is perfomed
acting on the screw accessible after removal
of front panel, under the tank door. (see
Fig.8)
1- Close gently all the way down the
dispenser by screwing anticlockwise the
needle valve of the dispenser.
2- Open up
quantity by screwing clockwise the
needle valve of the dispenser. (Fig.11)
tube inside the
Fig.11
Quantity for the first setting should be
according to the installator after evaluating the
hardness of the water and the type of rinse aid
used.
quantity is 0,16 gr/sec that correspond to the
maximum
Recommended detergent standard quantity is
0,77 gr/sec that correspond to the maximum
flow rate of the dispenser.
To check the effectivness of the rinse aid,
look at freshly washed glasses against the
light. Drops of water remaining on the glass
indicate an insufficient amount while streaks
indicate an excess. (next page)
to the installator
glasswasher. Maximum
DETERGENT DISPENSER
until reached necessary
Recommended rinse aid standard
flow rate of the dispenser.
SUGGESTION
after
dosing
10