Uninstall (Long Period Of Inactivity) - Adler DWA2050 Guide Rapide

In case of light coated presence that block
dispenser functions, remove the coat by soaking
the dishes for 30 minutes in a solution water
soap (1:10) before starting machine cycle.
2D3 – DISHWASHERS WITHOUT DETERGENT
DISPENSER
Manually add recommended detergent quantity
from the supplier every 5 cycles. Doses differ
depending on water hardness and soiled
quantity that remain on the dishes.
N.B.
All dishwashers are ready to be installed
external dispenser or specific dispenser kit
through injector and relative tube or through
the hole with relative cap located on the tank
of the machine.
If changing to a different detergent or rinse
aid type (even one
manufacturer), you must rinse the suction
and pressure hoses with fresh water before
connecting the new detergent or rinse aid
container. Otherwise, the mixing of different
types of detergent or rinse aid will cause
cristallisation, which
breakdown of the dosing pump. Failure to
observe this condition will invalidate the
guarantee and product liability.
WARNING!
DETERGENT SELECTION AND DOSAGE ARE
FUNDAMENTAL FOR
RESULTS AND TO
PERFORMANCES FOR
EXTENDED LIFE. FOLLOW ALWAYS THE
INSTRUCTIONS OF THE MANUFACTURER OF
CLEANNING AGENTS. IMPROPER DOSAGES
RESULT IN UNSATISFACTORY
RESULTS AND REPRESENT SOURCES OF
RIVERS AND SEAS POLLUTION. DO NOT USE
CORROSIVE OR POLLUTANT PRODUCTS TO
PROTECT AND MAINTAIN MACHINE, NEVER
EXCEED DOSAGES INDICATED BY DETERGENT
MANUFACTURER. NEVER
DISPENSER DRY OR
CORROSIVE OR FOREIGN PRODUCTS WHICH
WILL RESULT IN LOSS OF WARRANTY.
by the same
may result in a
WASHING GOOD
MANTAIN MACHINE
LONG TIME AND
WASHING
LEAVE THE
CHARGED WITH
2E - MAINTENANCE
1- Descale the boiler, the internal surface of
the tank and the appliance water piping
once or twice a year.
2- Descale the rinse and wash jets every
month using vinegar or a descaling
agent.
3- The internal hose of the rinse aid and
detergent peristaltic dispenser should
undergo periodic maintenance (once or
twice a year).
4- Clean solenoid valve filter by extracting it
from the inside of the valve and by
unplugging the water inlet tube.
2F - UNINSTALL (Long period of
inactivity)
Machine can be taken out of operation
only by trained specialists authorized for
the purposes, who will provide for:
1- Shut water line off (water valve) and
electric supply (main breaker).
2- Completely drain the tank.
3- Remove and carefully clean the filters.
4- Completely drain
dispenser hoses, removing them from
the containers.
5- Drain the detergent and rinse aid nozzles
with fresh water first and after with water
and glycerine (50% - 50%) taking care
that nozzles remain clean and lubrified
inside.
6- Drain completely
removing the screw located under the
machine.
7- Spread a thin film of vaseline oil over all
the stainless steel surfaces.
INSTALLATOR REMARKS
INSTALLATION DATE:________________________
INSTALLATION PLACE:_______________________
INSTALLATOR NAME:________________________
MACHINE SERIAL NUMBER:___________________
SIGNATURE:_______________________________
the incorporated
the booster by
11