Publicité
Les langues disponibles
Les langues disponibles
8130239
PERSONAL SAFETY
WARNING! Wear personal protective equipment approved by the Canadian Standards Association (CSA) or
American National Standards Institute (ANSI).
Personal Protective Equipment
1. Always wear impact safety goggles that provide front and side protection for the eyes.
2. Non-skid footwear is recommended to maintain footing and balance in the work environment.
3. Wear protective clothing designed for the work environment and tool.
4. This tool can cause hearing damage. Wear hearing protection gear with an appropriate Noise Reduction
Rating to withstand the decibel levels.
Personal Precautions
Control the tool, personal movement and the work environment to avoid personal injury or damage to tool.
1. Do not operate any tool when tired or under the influence of drugs, alcohol or medications.
2. Avoid wearing clothes or jewelry that can become entangled with the moving parts of a tool. Keep long hair
covered or bound.
3. Do not overreach when operating a tool. Proper footing and balance enables better control in
unexpected situations.
4. Support the workpiece or clamp it to a stable platform. Holding the workpiece by hand or against your
body may lead to personal injury.
GENERAL SAFETY PRECAUTIONS
Sharp Blade Precautions
DANGER! DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence
to circular saw safety rules. If you use this tool unsafely or incorrectly, you can suffer serious personal injury.
1. Keep hands away from cutting area and the blade.
2. Stable platform. It is important to support the work properly to minimize body exposure, blade binding, or
loss of control.
3. Always use blades with correct size and shape (diamond versus round) of arbor holes. Blades that do not
match the mounting hardware of the saw will run eccentrically, causing loss of control.
4. Never use damaged or incorrect blade washers or bolt. The blade washers and bolt were specially
designed for your saw, for optimum performance and safety of operation.
5. Do not use dull or damaged blades. Unsharpened or improperly set blades produce narrow kerf causing
excessive friction, blade binding and kickback. Keep blade sharp and clean. Gum and wood pitch hardened
on blades slows saw and increases potential for kickback. Keep blade clean by first removing it from tool,
then cleaning it with gum and pitch remover, hot water or kerosene. Never use gasoline.
6. Never force the saw. Forcing the saw will slow down blade rotation.
Electrical Safety
WARNING!
To reduce risk of electric shock, be certain that the plug is connected to a properly
grounded receptacle.
1. Disconnect tool from power source before cleaning, servicing, changing parts/accessories or
when not in use.
2. Protect yourself against electric shocks when working on electrical equipment. Avoid body contact with
grounded surfaces. There is an increased chance of electrical shock if your body is grounded.
3. Do not expose tool to rain or wet conditions. Water entering a power tool will increase the risk of
electric shock.
4. Do not disconnect the power cord in place of using the ON/OFF switch on the tool. This will prevent an
accidental startup when the power cord is plugged into the power supply.
Visit www.princessauto.com for more information
10 in. Wet Tile Saw with Stand
V 3.04
3
Publicité
