MINN KOTA RAPTOR PORT 4 Mode D'emploi page 9

3
d. With the Flange Nuts in place, pull the Red Retainer
out to release the hardware. There are handles on
each side of the Red Retainer that can be used to
grasp each half. When pulling the Red Retainer,
grasp each side and pull so that the Red Retainer
breaks at the center and releases the hardware.
NOTICE:
The Mounting Holes on the Jack Plate
are slotted so that the Raptor can be adjusted along
the slots for the final installation.
e. With the Red Retainer removed, there is slack
in the mounting hardware between the Port Jack
Plate Bracket and Built-in Mounting Bracket. This
allows the Built-in Mounting Bracket and Raptor
to be rotated for final Raptor placement along
the Slotted Holes in the Port Bracket. Check the
angle of the bracket along the Slotted Holes and
confirm that the Raptor is set at the desired angle.
Once set, hold the hardware inside the Jack Plate
Bracket with a 9/16" Open End Wrench. Tighten
the Flange Nuts with a 9/16" Box End or Socket
Wrench. Do not over-tighten. Tighten to 20 ft-lbs.
For warranty information, please visit minnkotamotors.com.
minnkotamotors.com
Part #2354911
3d
3e
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
ECN 40715
Handle Handle
Handle Handle
Red Red
Break Point Break Point
Retainer Retainer
Port Port
Bracket Bracket
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
3d
Red Red
Retainer Retainer
Break Break
Point Point
Handle Handle
Slotted Slotted
Holes Holes
Flange Nuts Flange Nuts
©2020 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Rev B 06/20