MINN KOTA RAPTOR PORT 4 Mode D'emploi page 8

Completing the Installation
1
a. Begin with the Port Bracket already installed to the
Jack Plate. For specific instructions, please refer to
the installation for each type of Jack Plate above.
Once the Jack Plate Bracket is secured, leave the
hardware and Red Retainer in place until instructed
to remove it and continue below.
NOTICE:
person help with installation.
2
ITEM(S) NEEDED
b. With the help of a second person, position the
Built-in Mounting Bracket on the Raptor, so that the
hardware in the Red Retainer on the Port Jack Plate
Bracket aligns with the Mounting Holes in the Built-
in Mounting Bracket. Apply Anti-seize (Item #22)
to the threads of the hardware held in place by the
Red Retainer. Then install the Built-in Mounting
Bracket to the hardware.
NOTICE:
hardware in the Jack Plate Bracket with the
Mounting Holes in the Built-in Mounting Bracket
to aide in installation. Keep the Red Retainer in
place until instructed to remove it.
c. Take four of the Flange Nuts (Item #20) and place
one on the end of each of the Hex Head Cap Screws.
Secure them loosely.
8 | minnkotamotors.com
It is recommended to have a second
#20 X 4
The Red Retainer helps to align the
1a
Hardware Hardware
Red Red
Retainer Retainer
Outboard Outboard
Jack Plate Jack Plate
Bracket Bracket
Transom Transom
#22 x 1
Red Red
2b
Port Port
Retainer Retainer
Bracket Bracket
2c
Jack Plate Jack Plate
Bracket Bracket
1a
Outboard Outboard
Jack Plate Jack Plate
Bracket Bracket
Hardware Hardware
Mounting Mounting
Holes Holes
Red Red
Retainer Retainer
Built-in Built-in
Mounting Bracket Mounting Bracket
©2020 Johnson Outdoors Marine Electronics, Inc.
Hardware Hardware
Red Red
Retainer Retainer
Built-in Built-in
Mounting Mounting
Bracket Bracket
Flange Flange
Nuts Nuts