MINN KOTA RAPTOR PORT 4 Mode D'emploi page 5

Installation with a Slidemaster Manual Jack Plate
Support the Outboard before any work has begun on the bracket installation. An unsecured motor may cause harm from falling. Make
sure that all hardware is replaced and/or secure before moving or operating the boat or Outboard once installation is complete.
1
ITEM(S) NEEDED
a. Locate the Mounting Holes on the Port side of the
Slidemaster Manual Jack Plate. After supporting the
Outboard, remove the hardware that is holding the
Slide Bar and Inner Threaded Plate in place.
NOTICE:
Any existing Side Bar should be removed
and not reused. The Inner Threaded Plate that came
with the Jack Plate will be reinstalled.
b. Take the Port Jack Plate Bracket (Item #2 or Item
#4) and align it with the Mounting Holes in the Port
side of the Jack Plate. Orientate the Port Bracket
so that the Red Retainer is facing Outboard and the
Slotted Mounting Hole is upward. Position the Inner
Threaded Plate back in place.
2
ITEM(S) NEEDED
c. With the Port Bracket aligned, take two 3" Stainless
Steel Hex Head Cap Screws (Item #18) and two
Heavy Duty Stainless Steel Washers (Item #14).
Place one Heavy Duty Washer on each of the Hex
Head Cap Screws. Apply anti-seize on the threads of
the Hex Head Cap Screws (Item #22).
d. Insert the Hex Head Cap Screws with the Heavy Duty
Washers in place through the Mounting Holes in the
Port Bracket, then into the Holes on the Port side
of the Jack Plate and then into the Inner
Threaded Plate.
e. Hold the Inner Threaded Plate in place and use a
1/2" Open End Wrench or Socket Wrench tighten
the Hex Head Cap Screws. Check with your specific
equipment manufacturer for their recommended
settings. Tighten hardware to 50 ft-lbs.
f. Continue to the "Completing the Installation" section
of these instructions.
5 | minnkotamotors.com
CAUTION
#2 x 1
#18 X 2 #14 x 2
#4 x 1
Inner Threaded Plate Inner Threaded Plate
1a
Mounting Bolts Mounting Bolts
Side Bar Side Bar
#22 x 1
2c Inner
Outboard
Threaded
Plate
Heavy Duty
Washers
Hex Head
Cap Screws
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Applying an anti-seize may help prevent seizing.
NOTICE:
The hardware on the inside of the Jack Plate is
secured into the Inner Threaded Plate. Two of the Heavy
Duty Stainless Steel Washers (Item #14) and two of the
Nylock Nuts (Item #16) will not be used.
Inner
1b
Red
Threaded
Retainer
Plate
Mounting
Holes
Slotted
Outboard
Mounting
Hole
2e
Inner Threaded
Plate
Outboard
©2020 Johnson Outdoors Marine Electronics, Inc.