MINN KOTA RAPTOR PORT 4 Mode D'emploi page 6

Installation with a Z-Lock Manual Jack Plate
Support the Outboard before any work has begun on the bracket installation. An unsecured motor may cause harm from falling. Make
sure that all hardware is replaced and/or secure before moving or operating the boat or Outboard once installation is complete.
1
ITEM(S) NEEDED
a. Locate the Mounting Holes on the Port side of the
Z-Lock Manual Jack Plate. After supporting the
Outboard, remove the hardware that is holding the
Mounting Bolts in place.
b. Take the Port Jack Plate Bracket (Item #2 or Item
#4) and align it with the Mounting Holes in the Port
side of the Jack Plate. Orientate the Port Bracket
so that the Red Retainer is facing Outboard and the
Slotted Mounting Hole is upward.
2
ITEM(S) NEEDED
c. With the Port Bracket aligned, take two 3" Stainless
Steel Hex Head Cap Screws (Item #18) and two
Heavy Duty Stainless Steel Washers (Item #14).
Place one Heavy Duty Washer on each of the Hex
Head Cap Screws. Apply anti-seize on the threads of
the Hex Head Cap Screws (Item #22).
d. Insert the Hex Head Cap Screws with the Heavy Duty
Washers in place through the Mounting Holes in the
Port Bracket and into the Holes on the Port side of
the Jack Plate.
e. Take two Heavy Duty Stainless Steel Washers (Item
#14) and place one on the end of each Hex Head
Cap Screw on the inside of the Jack Plate. Secure
the hardware with two Stainless Steel Nylock Nuts
(Item #16). Hold the Nylock Nuts with a 1/2" Open
End Wrench and tighten the Hex Head Cap Screws
with a 1/2" Socket Wrench. Check with your specific
equipment manufacturer for their recommended
settings. Tighten hardware to 50 ft-lbs.
f. Continue to the "Completing the Installation" section
of these instructions.
6 | minnkotamotors.com
CAUTION
#2 x 1
#18 X 2 #14 x 4
#4 x 1
1a
Mounting Bolts Mounting Bolts
#16 x 2
Mounting
2c
Port
Holes
Bracket
Heavy Duty
Washers
Hex Head
Cap Screws
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Applying an anti-seize may help prevent seizing.
1b
Slotted
Red
Mounting
Retainer
Hole
Mounting
Holes
Outboard
#22 x 1
Outboard
2e
Nylock
Nut
Heavy Duty
Washers
Nylock
Nut
Heavy Duty
Washers
©2020 Johnson Outdoors Marine Electronics, Inc.