Technical Data; Guarantee - ATIKA ADH 204 Notice Originale

Fault
Surface unsatisfactory.
Machined surface too rough.
Machined surface is shaky.
Chip exit blocked
Workpiece advance is slow during
thicknessing.

Technical data

Model / Type
Year of constructions
Power P
1
Mains voltage
Mains frequency
Mains fuse
Idle speed (cutting blades)
Feed rate for thicknessing
Max. workpiece width
Workpiece height for thicknessing
Depth of cut for planing
Depth of cut for thicknessing
Cutting blade dimensions
(length x width x thickness)
Table dimensions → Planing
Table dimensions → Thicknessing
Table height
Weight
Exhaust connection ∅
Commercial small dust removers or industrial vacuum cleaners can be used for exhaustion.

Guarantee

Please observe the enclosed terms of guarantee.
25
Possible cause
• Dull cutting blades
• Cutting blades blocked by shavings
• Erratic feeding
• Too much moisture in the workpiece
• Workpiece was machined against the growth
direction
• Too much material cut in a single pass
• keine Absaugung angeschlossen
• Too much moisture in the wood
• Resin on the thicknessing table plate
• Sluggish transport rollers
• Tension of the drive belt too low
ADH 204
see last page
1500 W (S1)
230
50 Hz
10 A inert
9000 rpm
6 m / min
204 mm
5 - 120 mm
0 - 3 mm
0 - 2 mm
210 x 16.5 x 1.5 mm
740 x 210 mm
270 x 210 mm
345 mm
approx. 26.5 kg
100 mm
Remedy
• Replace or sharpen the blades.
• Remove shavings.
• Feed the workpiece with constant pressure
and reduced speed.
• Dry the workpiece.
• Machine the workpiece in opposite direction.
• Machine the workpiece in multiple passes.
• Stop the machine, remove shavings and
connect the extractor.
• Use dry wood.
• Clean the table plate and apply a thin film of
sliding wax.
• Clean the transport rollers or have them
repaired
• Replace the drive belt
–
240 V~