Description Of Device / Spare Parts; Possible Faults - ATIKA ADH 204 Notice Originale

Description of device / spare parts

Y
no. Denomination
1 Guide plate
2 Feed table plate
3 Depth-of-cut scale
4 Adjusting screw for depth of cut
5 Height adjustment device
6 Pull-out workpiece support
7 Rubber feet
8 Motor protection switch
9 On / Off switch
10 Gearbox cover
11 Fixing screw for holder
12 Blade shaft guard
13 Holder for blade shaft guard
14 Blade shaft guard cpl.
15 Crank handle for thicknesser height
adjustment
16 Fixing screw for blade shaft guard
17 Delivery table plate
18 Thicknesser table plate
19 Scale for thicknesser height adjustment
20a Holder for pushing bar
20b Cable holder
21 Locking lever for angle adjustment

Possible faults

Before each fault clearance
− Switch off device
− Wait unitl the machine comes to a stop
− Pull out power plug

After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after
switching on or switches off during
idle running
Machine is stalled
machining.
Workpiece is jammed during
thicknessing.
Order-No.
363743
363744
363745
363746
363747
363748
363749
363750
363751
363752
363753
363754
363755
363756
363757
363758
363759
363760
363779
363761
363762
Possible cause
• Power failure
• Extension cable defect
• Motor or switch defect
• Carbon brushes worn.
during • Dull cutting blades
• Rate of feed too high
• Motor protecting switch has tripped
• Excessive depth of cut
no. Denomination
22 Angle adjustment scale
23 Hexagon socket screw key (Allan key)
to install the rubber feet
24 Hexagon socket screw key (Allan key)
for guide plate
25 Hexagon socket screw key (Allan key)
26 Open-end spanner for blade
replacement
27 Pushing block
28 Contact for safety switch
29 Extractor hood
30 Star grip screw
31 Exhaust connector
32 Blade setting gauge
33 Safety label
T
34 Blade shaft
U
35 Cutting blade
U
36 Clamping device
X
37 Driving belt
X
38 Roller chain
39 Tools cpl.
40 Pushing bar
41 Backstroke protection
F
42 Transport roller
Remedy
• Check the fuse.
• Check cable, no longer use defect cable
• Have motor or switch checked by an
approved electrician or replaced by original
spare parts
• To correct the problem, refer to the
manufacturer or costumer service.
• Replace or sharpen the blades.
• Continue working with slower rate of feed.
Switch motor back on after cooling (see
Motor protection
"
• Reduce depth of cut and machine workpiece
in multiple passes.
Order-No.
363763
363764
363765
363766
363767
363768
363742
363769
363770
363771
363772
363773
363774
361110
F
)
"
24