Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Contents
EC Declaration of Conformity
EC Declaration of Conformity
No. (S-No.): 10404
according to EC directive: 2006/42/EC
We,
ATIKA GmbH
Josef-Drexler-Str. 8 - 89331 Burgau - Germany
herewith declare under our sole responsibility that the product
Abricht- und Dickenhobel (Surface planing and
thicknessing machine) model / type ADH 204
Serial number: 000001
-
is conform with the above mentioned EC directive as well as with
the provisions of the guidelines below:
2014/30/EU and 2011/65/EU.
Following harmonized standards have been applied:
EN 61029-1/A11:2010; EN 61029-2-3:2011;
EN 55014-1/A2:2011; EN 55014-2/A2:2008;
EN 61000-3-2:2014; EN 61000-3-11:2000
Keeping of technical documents at:
ATIKA GmbH
Technical department
-
Josef-Drexler-Str. 8 - 89331 Burgau - Germany
ppa.
Burgau, 08.09.2016
ppa. G. Koppenstein,
Engineering design management
Extent of delivery
• Surface planing and thicknessing machine ADH 204
• Shavings exhaustor hood
• Shavings exhaustor connector
• 1 pushing block
020000
• 1 pushing bar
• Blade shaft guard
16
• Guide plate
16
• Crank handle for height adjustment
16
• Cutting blade setting gauge
16 / 17
• 4 rubber feet
17
• Installation tools
17
• Fasteners
17
• Operating manual
19
19
After unpacking, check the contents of the box
20
That it is complete
20
Check for possible transport damage
22
Report any damage or missing items to your dealer, supplier or
23
the manufacturer immediately. Complaints made at a later date
23
will not be acknowledged.
23
24
24
Characteristics noise values
25
25
EN ISO 3744
Machine used as surface planer and thicknesser with standard
cutting blades.
Noise power level
L
= 105,9 dB(A)
WA
The factor of measurement uncertainty is 3 dB.
The values given are emission values and must therefore not
simultaneously represent safe workplace values too. Although there is
a relationship between emission and immersion levels, it can be
reliably deduced whether additional precautionary measures are
necessary or not. Factors, which can influence the immersion level
currently existing at the workplace include the duration of the effects,
the special type of the workroom, other noise sources, etc. e.g. the
number of machines and other adjacent processes. The permissible
workplace values can also vary from country to country. This
information should however enable an improved assessment of the
danger and risk to be carried out.
Symbols machine
safety instructions before
starting the machine and
observe the instructions when
operating.
Wear eye and ear
protection
Sound pressure level at the workplace
L
pA
Carefully read
operator
s
'
manual and the
Risk of finger and
hand injury by
the cutting blade.
Wear dust mask.
= 92,9 dB(A)
Shut off engine
and remove power
cord before
performing
cleaning,
maintenance or
repair work.
Do not expose to
rain. Protect
against humidity.
Wear protective
gloves.
16
Publicité
Chapitres
Table des Matières
