Transport; Storage; Maintenance And Cleaning Schedule - ATIKA ADH 204 Notice Originale

Transport

Remove mains plug before each transport.

Before any transport make sure that the blade shaft guard fully covers the blade shaft.
This will avoid injury by the blades.
When handling do not take hold on the feed or delivery table. Take hold on the bottom of the machine.

Storage

Pull out power plug.
 Store unused equipment in a dry, locked place out of the reach of children.
 Before a longer period of storage carry out the following to extend the machine
− Carry out a thorough cleaning and maintenance.

Never use any grease!

Maintenance and cleaning schedule

Before each starting
After each use
Once in a month (if used
daily)
23
Check
•
the backstroke protection,
•
the cutting blades,
•
the transport rollers (42)
•
the feed and delivery tables.
Check and clean
•
the interior of the machine,
•
the threaded rods of the height
adjustment,
•
exhaust connector.
Check
•
the threaded rods of the height
adjustment,
•
anschlusskabelthe mains cord.
'
s service life and ensure an easy operating:
The grippers must fall back automatically and the tips must not
be rounded.
F
The cutting blades must be sharp and properly secured.
,
Check that the coating shows no damages and that the
workpieces are conveyed without problems?
Apply a thin film of sliding wax.
Remove wood dust and shavings.
Slightly spray with maintenance spray.
Check for damages and have it replaced by an electrician if
required.