Haier HMV1640 Instructions D'installation page 16

7. Secure blower unit to microwave with the blower motor screw removed in
Step 1. Completely tighten the screw.
a
8. Replace blower plate with the blower plate screw removed in Step 1. Completely
tighten the screw.
9. Slide the exhaust adapter onto the guides on top of the blower plate.
10. Push in firmly until the exhaust adapter is in the locking tabs. Ensure that the
damper hinge is installed so that the damper swings freely.
a
CHECK DAMPER OPERATION
1. Remove tape securing the damper to the exhaust adapter, and then make sure
the damper pivots easily.
2. Make adjustments to ensure proper alignment with the house exhaust duct
once the microwave is mounted.
a
14
b
a
b
c
d
e
b
c
a
AFTER: Fan Blade
Openings Facing Top
b
Back of Microwave
a
Back of Microwave
a
Guide
b
Damper
c
Adapter
d
Back of Microwave
e
Locking Tab
a
Blower Plate
b
Exhaust Adapter
c
Damper
d
Back of Microwave
d