Haier HMV1640 Instructions D'installation page 22

4. Rotate blower unit counterclockwise 180°.
Before Rotation
5. Gently remove the wires from the grooves. Reroute the wires through grooves
on other side of the blower unit.
Before Rerouting
Wires Routed Through Right Side
6. Roll the blower unit 90° so that fan blade openings are facing out the back of the
microwave.
Before Rolling
7. Remove the knockout plates in the back of the unit with snips.
8. Place the blower unit back into the opening.
IMPORTANT:
•
Make sure the wires are not pinched and that they are properly secured.
•
The blower unit exhaust openings should match exhaust openings on the
rear of the microwave oven.
20
After Rotation
a
After Rolling
a
a
Back of Microwave
a
After Rerouting
Wires Routed Through Left Side
a
Back of Microwave
a
a
Knockout Plates
a