Installation Requirements; Tools And Parts - Haier HMV1640 Instructions D'installation

INSTALLATION REQUIREMENTS

TOOLS AND PARTS

PARTS PROVIDED
Wood Screws
(1⁄4" x 2")
Nylon Grommet
(for metal cabinets)
Separately Packed
Grease Filters
Turntable Ring
TOOLS AND MATERIALS NEEDED
•
Phillips Screwdriver
•
Pencil
•
Ruler or Tape Measure and Straight
Edge
•
Carpenter's Square (optional)
•
Tin Snips (for cutting damper, if
required)
•
Scissors (to cut template, if
necessary)
•
Cordless Drill with 3⁄16", 1⁄2" and 5⁄8"
drill bits
Toggle Bolts (and wing nuts)
(3⁄16" x 3")
TOP CABINET TEMPLATE
Top Cabinet Template
Exhaust Adaptor
•
Filler blocks or scrap wood pieces,
if needed for top cabinet spacing
(used on recessed bottom cabinet
installations only)
•
Gloves
•
Saw (saber, hole or keyhole)
•
Stud Finder or Hammer (optional)
•
Safety Goggles
•
Level
•
Duct and Masking tape
Self-Aligning Machine Screws
(1⁄4"-28 x 31⁄4")
REAR WALL TEMPLATE
Rear Wall Template
Glass Tray
3