Haier HMV1640 Instructions D'installation page 26

4. Push the mounting plate flush against the wall. Make sure the tabs on the
mounting plate touch the bottom of the cabinet or the horizontal line if
mounting under a cabinet with a front overhang, and that the plate is properly
centered under the cabinet.
NOTE: Avoid pinching fingers between the back of the mounting plate and the
wall.
d
e
a
f
b
5. Tighten all bolts.
NOTE: Pull the plate away from the wall to help tighten the bolts.
PREPARE OVERHEAD CABINET
1. Read the instructions on the TOP CABINET template, and then tape the
template underneath the overhead cabinet.
2. Drill the holes following the instructions on the template.
•
Drill holes for the top support screws.
•
Drill a hole large enough for the power cord to fit through.
•
Drill a cutout large enough for the exhaust adaptor.
24
a
b
c
d
e
c
f
Mounting Plate
Wall
Bolt End
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Toggle Bolt