Step 3 - Align Rear Wall Template And Mark Wall - Haier HMV1640 Instructions D'installation

STEP 3 - ALIGN REAR WALL TEMPLATE AND MARK
WALL
Overhead cabinet styles vary. Follow the instructions that apply to the cabinet style
in your home.
IMPORTANT: Disconnect power to electrical outlet.
STYLE 1 - FLAT-BOTTOM CABINET
1. Draw a vertical line on the wall at the center of the 30" (76.2 cm) wide space.
2. Tape the Mounting Plate/Rear Wall Template onto the wall matching the
centerline and touching the bottom of the cabinet.
STYLE 2 - FRAMED, RECESSED CABINET
1. Draw a vertical line on the wall at the center of the 30" (76.2 cm) wide space.
2. Tape the Mounting Plate/Rear Wall Template onto the wall matching the
centerline and touching the bottom cabinet frame.
NOTE :
IT IS VERY
READ IMPO RTAN
IN THE AND FOLL
INST ALLA OW THE T TO
BEFO RE TION INST DIRE CTIO
REAR PRO CEED NS
WAL L ING WITH RUC TION
This Rear TEMP LATE THIS S
Wall Templa .
mounti ng plate and te serves 12"
outlet. to locate to position
1. Use the horizon the bottom
accura tely. a level to check tal exhaus t
2. Locate that the templa te
and mark is position
right side at least ed 4"
of the centerl one stud on the left
screw mounte It is importa ine. or
d firmly nt to use at least
of the microw in a stud one wood
location s for the ave. Mark two additio to suppor t the weight
3. Drill holes supplie nal, evenly
a stud, in the marked d toggle bolts. spaced
drill a 3/16" location
that do not line hole for wood screws s. Where there is
toggle bolts. up with a stud, . For holes
drill 5/8"
AT THIS DO NOT INSTA LL holes for
TIME. THE MOUN
4. Remov e the templa TING PLATE
5. Review te from
installa tion the Installa tion Instruc the rear wall.
situatio n. tion book
for your
Darle vuelta
versió n a la hoja
en Españ para consu
ol. ltar la
Loca te
and mark
moun ting holes to
plate . align with
IMPO RTAN holes in
T: the
LOCA TE
THE CENT AT LEAS
T ONE STUD
MAR K ERLI NE. ON EITH
THE LOCA ER SIDE
SPAC ED TION FOR OF
TOG GLE 2 ADDI
AREA . BOLT S TION AL,
IN THE EVEN LY
MOU NTIN
G PLAT
E
Trim the
rear wall
temp late
along the dotte
d line.
a
8
a
3/8" TO EDGE
Trim the
rear wall
temp late
along
the dotte
d line.
Loca te
and mark
moun ting holes to
plate . align with
IMPO RTAN holes in
T: the
LOCA TE
AT LEAS
THE CENT T ONE
MAR K ERLI NE. STUD ON EITH
THE LOCA ER SIDE
SPAC ED TION FOR OF
TOG GLE
AREA . BOLT S 2 ADDI TION AL,
IN THE EVEN LY
MOU NTIN
G PLAT
E
33" to cooktop
16½"
(41.9 cm)
a
Center Line
a
Center Line