MOOD KORSIKA Traduction Des Instructions D'origine page 87

12 – Safety instructions for assembly
- Technical knowledge is required to assemble the awning. Do not assemble this awning yourself if you
o are not sure whether the waning can be installed in the location chosen.
o do not understand the instruction manual or parts of it.
o do not have the necessary tools.
o do not have the necessary technical knowledge.
- Never change the design or configuration of the system without consulting the manufacturer or an
authorised representative, as this can result in a dangerous situation.
- Do not assemble the awning if you find damaged parts or if parts are missing.
- When extended, the awning is affected by various forces, including wind and rain. These sometimes
considerable forces have to be absorbed by the awning and transmitted to the structure via the mounting
brackets. Under extreme loads, excessive force can be exerted on the securing anchors. Therefore, before you
start assembling the waning, check the load-bearing capacity of the fastening structure and, if necessary, take
the necessary measures to ensure that the brackets are securely fastened. If the attachment is not secure, you
should consult a specialist in your area.
13 – Tools and accessories recommended for installation
- Power drill with matching drill bits
- Wrench/spanner
- Soft face hammer
- Allen key
- Tape measure
- Spirit level
- Screwdriver
- Pliers
- Brush for cleaning the drilled hole
211021_MOOD_BDA Markisen_Korsika_RZ.indd 87 211021_MOOD_BDA Markisen_Korsika_RZ.indd 87
EN 87
21.10.21 15:03 21.10.21 15:03