Heiniger StyleMini Mode D'emploi page 18

Use only the original attachment combs.
Do not use a damaged attachment comb.
WARNING before working on or with animals
Working on animals should only be performed by people who are experi-
enced in cutting animal hair or who work under the guidance of an experi-
enced person.
Do not use the device on a restless or aggressive animal.
Animals must be calmed down and, if necessary, fixed before cutting.
Make sure that your workplace is quiet and always work with the necessary
caution.
Depending on the type of animal, protective gloves may be required as per-
sonal protective equipment.
Stop working immediately if the animal behaves conspicuously or becomes
aggressive.
ATTENTION! Risk of material damage
The cutter head is a precision part. Protect it against damage.
In order to avoid increased wear of the cutter head and motor, the cutter head
must be cleaned and oiled regularly (see "Cleaning and care" on page 18).
Do not use any sharp or abrasive cleaning agents.
The battery charger is fitted with non-slip plastic feet. As furniture is coated
with a wide array of varnishes and synthetics, and is also treated with differ-
ent care products, it cannot be fully ruled out that some of these materials
contain components that could attack and soften the non-slip plastic feet. If
necessary, place a non-slip mat under the appliance.
Protect the appliance against heat (e.g. direct sunlight), chemical substances
(e.g. perm agents) and mechanical damage (e.g. by dropping).
16 ENGLISH
Specifications according to Machinery Directive 2006/42/EC
A-weighted emission sound pressure level at workstations at a distance of
1 m, L pA ≤ 70 dBA
measured maximum noise emission value, including uncertainty of measurement
according to EN ISO 4871. Determination of the values according to EN 60704-2-9
with reference to EN 60704-1
Vibration total value to which the hand-arm system is subjected,
2
a h < 2.5 m/s
measured maximum vibration total value including uncertainty of measurement.
Determination of the values according to EN ISO 5349-1/2
Designation of the Parts
1 Charge contacts
2 Charging station
3 Charge status display
4 On/Off switch
5 Cutter head
6 Charge contacts of the appliance
7 Plug-in power supply device
(model T10)
8 Release key
9 Mains plug adapter (replaceable,
figure: EURO version)
10 Connecting cable
11 Comb attachment
12 Oil bottle
13 Cleaning brush