Publicité
Les langues disponibles
Les langues disponibles
Lay the connecting cable such that no one can step on it, get caught on it, or
trip over it.
Please be careful not to damage the connecting cable:
– Keep the connecting cable away from hot surfaces and sharp edges.
– Ensure that the connecting cable cannot be trapped or crushed.
– Do not wrap the connecting cable around the appliance. The cable may
break.
To pull the power supply unit out of the power socket, always pull on the
power supply unit, and never on the connecting cable.
Pull the power supply unit out of the power socket, ...
– after every use,
– after each charging process,
– if there is a fault,
– before you clean the appliance and
– during thunderstorms.
Ensure that the power supply unit cannot be plugged in again during cleaning.
To avoid any hazard, do not make modifications to the appliance. You also
must not replace the connecting cable yourself. Repairs must be carried out
exclusively by your authorised customer service centre.
Use only the original mains plug adapters.
Use only original spare parts, which you can order from the customer service
centre (see the back of these user instructions). If the connecting cable is
damaged or crushed, it and the plug-in power supply device need to be com-
pletely replaced.
WARNING! Risk from batteries
Protect the battery against mechanical damage. Fire hazard!
Do not expose the appliance to direct sunshine or heat. The ambient temper-
ature should not be lower than -10 °C or higher than +40 °C.
The charge contacts on the appliance must not be connected by metallic objects.
Charge the appliance's built-in battery exclusively using the original acces-
sory parts.
The appliance must only be operated with the original power supply unit
T10.
If the electrolyte solution leaks out of the battery, avoid contact with eyes,
mucous membranes and skin. Rinse immediately with plenty of clean water
and consult a doctor. The electrolyte solution can cause irritation.
The appliance contains a lithium ion battery.
– This appliance must not be opened!
WARNING! Risk of injury from cutting
Do not use the appliance with a damaged or fractured cutter head.
The cutter head must not be disassembled.
While the appliance is switched on, do not touch the cutter head.
The appliance must be switched off:
– when mounting or removing an attachment comb.
– when you put down the appliance, e.g. when you interrupt the cutting pro-
cess briefly.
– before removing or mounting the cutter head,
– before cleaning the appliance.
ENGLISH
15
Publicité
