Proxxon COLT 2 Manuel D'utilisation page 7

Important:
Always clamp tools securely.
Changing the drill chuck
Note:
The drill chuck has a
M8 x 0.75 thread.
1. Fully open drill chuck.
2. Block shaft with an Allen key
(4 mm) (Fig. 3).
3. Turn to left to release drill chuck,
turn to right to tighten.
Working with the machine
Important:
Never work without safety goggles
when grinding.
Do not work with bent drills or
shafts.
Change blunt drills in good time.
Note:
Do not overload machine. Always
maintain sufficient speed to ensure
that the motor is ventilated.
EC Declaration of conformity
Name and address:
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
Product designation: COLT 2
Article No.:
In sole responsibility, we declare
that this product conforms to the
following directives and normative
documents:
EU EMC Directive
2004/108/EC
DIN EN 55014-1 / 02.2010
DIN EN 55014-2 / 06.2009
DIN EN 61000-3-2 / 03.2010
DIN EN 61000-3-3 / 06 2009
EU Machinery Directive
2006/42/EC
DIN EN 60745-1 / 01.2010
Date: 28.09.2012
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Machine Safety Department
The CE document authorized agent
is identical with the signatory.
28490
- 7 -