Publicité
FRONT FORK OIL SEAL AND DUST SEAL CLEANING
FRONT FORK INSPECTION/
3. Adjust:
Drive chain slack adjustment steps:
Loosen the axle nut 1 and locknuts 2.
Adjust chain slack by turning the adjusters 3.
To tighten → Turn adjuster 3 clockwise.
To loosen → Turn adjuster 3 counter-
clockwise and push wheel forward.
5PA30560
Turn each adjuster exactly the same
amount to maintain correct axle alignment.
(There are marks a on each side of chain
puller alignment.)
NOTE:
Turn the adjuster so that the chain is in line
with the sprocket, as viewed from the rear.
CAUTION:
Too small chain slack will overload the
engine and other vital parts; keep the
slack within the specified limits.
Tighten the axle nut while pushing down
the drive chain.
Tighten the locknuts.
EC36C000
FRONT FORK INSPECTION
1. Inspect:
Front fork smooth action
Operate the front brake and stroke the front
fork.
Unsmooth action/oil leakage → Repair or
replace.
5PA30570
EC36D001
FRONT FORK OIL SEAL AND DUST SEAL
CLEANING
1. Remove:
Protector 1
Dust seal 2
NOTE:
Use a thin screw driver, and be careful not to
damage the inner fork tube and dust seal.
5PA30580
3 - 24
INSP
Drive chain slack
Axle nut:
110 Nm (11.0 m • kg, 80 ft • lb)
ADJ
Publicité
