Attaching The Tail Unit; Connecting The Wings - Carson Skydreamer Mode D'emploi

ATTACHING THE TAIL UNIT

For reasons of transportation the tail assembly is
not mounted when supplied. First of all, connect
the servos for the horizontal and vertical stabilisers
and tuck the cable away.
To glue them together, you need to apply
superglue to one side, and activator to the other. If
you only use superglue you will have to hold the
parts in the correct position for significantly longer
than usual. Oil the hinge at the shaft lightly so that
it stays moveable. The gluing surface must remain
clean. Secure the horizontal stabiliser followed by
the vertical stabiliser, taking care to position
them at a right angle. Check that the
tail assembly functions by operating
the transmitter.
If horizontal and vertical are
reversed on the transmitter, pull the
plugs in channels 1 and 2 out and
plug them back in the opposite way round.
ASSEMBLING THE WINGS
Carbon fibre tube
The wings of the Skydreamer are not attached
for ease of transportation. Carbon fibre
wing spar tubes hold them in position by the
frictional and restraining force of the Elapor.
Push the wings onto the tube using a gentle
screwing action until they are completely
integrated into the fuselage. Do not use any force
SKYDREAMER CARSON R/C MODEL AIRCRAFT 50 050 5011
and always hold on to a well-chosen
point of application of force. Carry out the above
procedure in reverse to take apart.
GB GB
13