Pulsar ACCOLADE Serie Instructions page 12

Enter the Format submenu with a short press of
=
the M button.
Press briefly М to confirm.
=
With a short press of the UP/ DOWN buttons
=
select "Yes" to format the memory card or "No"
to return to the submenu.
Confirm selection with a short press of the M
=
button.
If "Yes" is selected, display will show "Do you
=
want to format memory card?" and "Yes" and
"No" options. Select "Yes" to format the memory
card.
Message «Memory card formatting» means
=
that formatting is in progress.
Upon completion of formatting the message
=
«Formatting completed» is shown.
If "No" is selected, formatting is aborted and you
=
return to the submenu.
Remote
Remote control activation (bought separately)
Control
Before operating the remote control (RC),
remember to activate it as follows:
Press and hold down the М (3) button to enter the
=
main menu.
Select option "
=
(2)/DOWN (5) buttons. Press briefly М to confirm.
Press briefly М to confirm.
=
Display shows message "Wait" and countdown
=
starts (30 sec), within which hold down for two
seconds any RC button.
If activation is successful, the message
=
«Connection complete» appears
If error occurs the message «Connection failed»
=
appears
The RC is activated and ready for use.
=
To unlink the RC, press the М button, wait for the
=
countdown to expire without pressing any RC
button for 30 sec.
All remote controls previously linked to your
=
device are now unlinked.
17
Remote Control " with the UP
.
. Repeat the procedure.
Defective
Defective pixel repair
pixel repair
When operating a thermal imager, defective (dead)
pixels (bright or dark dots with constant brightness)
may become visible on the sensor.
ACCOLADE thermal binoculars allow the user to
repair defective pixels on the detector using a
software-based method or to abort deletion.
Press and hold down the М (3) button to enter the
=
main menu.
G
Select option "
=
(2)/DOWN (5) buttons. Press briefly М to confirm.
H
Press briefly М to confirm.
=
x=95
I
A marker (H)
y=99
=
display.
On the right side of the display appears
=
"magnifying glass" (G) – a magnified image in a
frame with a fixed cross
detection of a defective pixel and to match the
pixel with the marker, horizontal and vertical
arrows for X and Y axes (I) showing marker's
movement.
With a short press of the UP/ DOWN buttons
=
move the marker to align it with a defective pixel.
Switch the direction of the marker from horizontal
=
to vertical and vice versa with a short press of the
M button.
Align the defective pixel with the fixed cross in the
=
frame – the pixel should disappear.
Delete the defective pixel with a short press of the
=
REC (4) button.
A brief message "OK" appears in the frame in
=
case of success.
Then you can delete another defective pixel by
=
moving the marker along the display.
Exit "Defective pixel repair" with a long press of
=
the M button.
Return to default defective pixel pattern
This option allows you to cancel deletion of the
defective pixels and return them to the original
state.
Enter the submenu with a short press of the M
=
button.
Select icon
=
Select "Yes" if you wish to return to default
=
defective pixel pattern, or "No" if you do not.
Confirm selection with a short press of the M
=
button.
Defective pixel repair " with the UP
appears on the left side of the
, designed for easier
and press М.
18