Users Set-Up - df models drive & fly I-PEAK 6 Instructions D'utilisation

more charge cycles. The cyclic process of charge and discharge will optimize the capacity of
battery pack.

USERS SET-UP

LIXX V. Type
LiFe
V. Type 3.3V
-
<"DEC"
LIXX Check Time
LiPo/Lilo/LiFe
CHK Time 10 min
-
<"DEC"
rectly. You need to extend the time term limit for the battery of large capacity. But the charge
or discharge process may come to an end within the time term because of the time limit
decided by the wrong count if you set too long time limit for the battery of small capacity.
This may cause fatal error. You have to extend the time term if the processor detect the cell
count incorrectly at the beginning of charge or discharge process. Otherwise, default value is
recommended to use.
Delta Peak Sensitivity
NiMH Sensitivity
D. Peak Default
-
<"DEC"
NiCd Sensitivity
D. Peak Default
-
<"DEC"
Temperature detection
Temp Select
Enabled
-
<"DEC"
Temp Cut-Off
Temp Select Temp
Cut-Off 80C
-
<"DEC"
The screen shows the nominal voltage of Lithium batteries. There
are three kinds of Lithium batteries: LiFe(3.3V), Lilo(3.6V) or
LiPo(3.7V). This information is of critical importance! You have to
check the battery carefully to make sure it is set up correctly. If it
+
is different from correct value, explosion can occur during charge
"INC">
process.
To avoid from erroneous setting by users, I-Peak 6 detects the
cell count of Lithium battery automatically at the beginning
of charge or discharge process. But a battery that is deep-
discharged can't be detected correctly. To avoid this error, the
+
time term can be set to verify the cell count by the processor.
"INC">
Normally, 15 seconds are enough to detect the cell count cor-
The "NIMH Sensitivity D. Peak" shows the trigger voltage for au-
tomatic charge termination of NiMH and NiCd battery. The valid
value ranges from 5 to 20 mV per cell. Setting the trigger voltage
higher brings a danger of overcharging; whereas setting it lower
+
"INC">
brings a possibility of premature termination. Please refer to the
technical specifi cation of the battery. (NiCd default:12mV, NiMH
default:7mV)
+
"INC">
There is a 3-pin port on the left of the charger used as tempera-
ture sensor port. When the screen displays "Temp", you can use
the optional temperature probe to connect to the surface of the
battery.
+
"INC">
The maximum temperature of the battery can be set during the
charge process. The process will be terminated automatically
to protect battery once the temperature of battery reaches this
value. This feature is accomplished through temperature probe
+
(optional).
"INC">
www.df-models.com
7