Load Data Program; Various Information In The Program - df models drive & fly I-PEAK 6 Instructions D'utilisation

Load data program

This program is to load the data stored at the "save data" program. Press "Start/Enter" key to make the data
fi eld blink and press "INC"or"DEC" for more than 3 seconds to load the data.
PROGRAM SELECT
LOAD DATA
Start
Enter
LOAD [01] NiMH
14.4V 3000mAh
Start
Enter > 3 sec
Load ...

VARIOUS INFORMATION IN THE PROGRAM

You can inquire various information on the LCD screen during the charging and discharging proc-
ess. Press "DEC"key, the charger will display users' setting. You can press "INC" key to monitor
voltage of each cell while the battery is connected with each port of the charger.
End Voltage
12.06V(3s)
Capacity Cut-Off
ON 5000mAh
Safety Timer
ON 200min
USB/Temp Select
USB Enabled
Ext.Temp 26C
IN Power Voltage
12.56V
4.14 4.16 4.09
0.00 0.00 0.00
Choose the data number you want to call back. The data you want to call back will
be displayed.
Loading the data.
The fi nal voltage when the program ended.
3-pin connector is selected to be the USB port.
The external temperature is displayed when the temperature probe is used.
Present input voltage.
The battery is connected with each port through cable; you can
check voltage of each cell in the battery pack. When the cable is
connected with the ports on the right of the charger, the program
will display voltage of up to 6 batteries. The battery pack needs an
balancer connector connected with each cell.
www.df-models.com
17