Warning And Safety Notes - df models drive & fly I-PEAK 6 Instructions D'utilisation

WARNING AND SAFETY NOTES

These warnings and safety notes are particularly important. Please follow the instructions for
maximum safety; otherwise the charger and the battery can be damaged or at worst it can
cause a fi re. Also read the chapter "Before you begin".
• Never leave the charger unsupervised when it is connected to a power supply. If any malfunction
is observed immediately terminate the process and refer to the operation manual.
• Keep the unit away from dust, damp, rain, heat, direct sunshine and vibration. Do not drop it.
• The circuit of the unit is designed to be powered by an 11-18V power source .
• This unit and the battery to charge or discharge should be set up on a heat-resistant, noninfl am-
mable and nonconducting surface. Never place them on a car seat, carpet or similar surface.
• Never use this charger inside a car, van or any other motor vehicle.
• Keep all infl ammable volatile materials well away from the chargers operating area.
• Never charge batteries fi tted inside models, always remove them before charging.
• Make sure you know the specifi cations of the battery to be charged or discharged to ensure
it meets the requirements of this charger. If the program is set up incorrectly the battery and
charger may be damaged and cause a fi re.
NiCd/NiMH Voltage level:
Allowable fast charge current:
Discharge voltage cut off level:
Li-ion Voltage level:
Max. charge voltage:
Allowable fast charge current:
Min. discharge voltage cut off level:
LiPo Voltage level:
Max. charge voltage:
Allowable fast charge current:
Discharge voltage cut off level:
LiFe Voltage level:
Max. charge voltage:
Allowable fast charge current:
Discharge voltage cut off level:
Pb Voltage level:
(Lead-acid) Max. charge voltage:
Allowable fast charge current:
Discharge voltage cut off level:
- To avoid short-circuits between the charge lead always connect the charge cable to the charger
fi rst, then connect the battery. Reverse the sequence when disconnecting.
- Do not connect more than one battery pack to this charger at any one time.
- Do not attempt to charge or discharge the following types of battery.
- A battery pack which consists of different types of cell (including different manufacturers)
- A battery that is already fully charged or just slightly discharged.
- Non-rechargeable batteries (Explosion hazard).
- Batteries that require a different charge technique from NiCd, NiMH, Li-Poly or Gel cells (Pb).
- A faulty or damaged battery.
- A battery fi tted with an integral charge circuit or a protection circuit.
- Batteries installed in a device or which are electrically linked to other components.
- Batteries that are not expressly stated by the manufacturer to be suitable for the currents the
charger delivers during the charge process.
www.df-models.com
1.2V/cell
1C-2C (depends on the performance of cell)
0.85V/cell (NiCd), 1.0V/cell (NiMH)
3.6V/cell
4.1V/cell
1C or less
2.5V/cell or higher
3.7V/cell
4.2V/cell
1C or less
3.0V/cell or higher
3.3V/cell
3.6V/cell
4C or less
2.0V/cell or higher
2.0V/cell
2.46V/cell
0.4C or less
1.75V/cell or higher
3