Discharge Of Nicd/Nimh Battery; Charge/Discharge And Discharge/Charge Cycle Of Nicd/Nimh Battery - df models drive & fly I-PEAK 6 Instructions D'utilisation

But in the manual mode, it will charge with the current you set. You can make it blink in the cur-
rent fi eld and press "INC"and"DEC" at the same time to switch mode.
The screen shows the real-time status. Press "Batt type/Stop" key to end the program. The
sound will emitted to indicates the end of program.

Discharge of NiCd/NiMH battery

Set charge current on the left and the fi nal voltage on the right. Range of the charge current is
0.1-1.0A; range of fi nal voltage is 0.1-25.0V. Press "Start/Enter" key for more than 3 seconds to
start the program.
The screen indicates the discharging state. You can press "Start/Enter" key to alter discharge
current. Press "Start/Enter" again to store the value. Press "Batt type/Stop" key to stop discharg-
ing. The emitted sound alerts the end of discharging.

Charge/discharge and discharge/charge cycle of NiCd/NiMH battery

You can set up sequence on the left and the number of cycles on the right. You can balance,
refresh and break-in the battery with this function .You can set a temporary cool-off procedure in
the user's setting. Range of the cycle number is 1-5.
NIMH
DCHG>CHG
Battery type
Elapsed time
Charging current
Battery type
NIMH
CHG
Elapsed time
NIMH
1.0A
Battery type
Discharge current
NIMH 1.0A
CHG
Elapsed time
Press "Batt type/Stop" key to stop program, you can press
CYCLE
Start/Enter" key to alter charge current. The sound indicates
3
the end of program.
Discharge or charge current
NIMH
D>C
www.df-models.com
Battery voltage
2.0A 7.42V
022:45 00890
Charged capacity
DISCHARGE
11.5V
Battery voltage
7.42V
022:45 00890
Discharged capacity
1.0A 7.42V
022:45 00890
Battery voltage
Supplied capacity
15