Controls - df models drive & fly I-PEAK 6 Instructions D'utilisation

Capacity limit:
Temperature threshold: The battery's internal chemical reaction will cause the temperature of
Processing time limit:
Input power monitoring: To protect the car battery used as DC input power from being damaged,
Data store/load
The maximum fi ve batteries' data can be stored for users' convenience. You can keep the data
pertaining to program setting of the battery of continuous charging or discharging. Users can call
out these data at any time without any special program setting.
Cyclic charging/discharging
1 to 5 cyclic and continuous process of charge>discharge or discharge>charge is operable for
battery refreshing and Balancing to stimulate the battery's activity.

CONTROLS

Input power cable
100 ~ 240V • 50/60Hz
Input power cable
11-18V DC
Output charge lead
4mm banana plug
Important!
Please take note of the proper connection method when charging LiPo batteries (page 8). Incor-
rect use will damage the charger.
Insulate the croc clips when using the mains supply! When they touch each other, they will cause
a short circuit.
The charging capacity is always calculated as the charging current mul-
tiplied by time. If the charging capacity exceeds the limit, the process
will be terminated automatically when you set the maximum value.
the battery to rise. If the temperature limit is reached, the process will be
terminated. This function is available by connecting optional tempera-
ture probe, which is not included in our package.
You can also limit the maximum process time to avoid any possible defect.
its voltage keeps being monitored. If it drops below the lower limit, the
process will be ended automatically.
Temperature
Sensor port
• Scroll through the Main Menu
• Stop any charge processes
Balance Lead sockets
JST-XH ports
www.df-models.com
LCD Screen
16 Characters
• Resume or Start charge
processes
• Confi rm an action
• Alter values
• See the status of individual
cells in balance charge mode
5