Storage Control Of Lithium Battery; Discharging Of Lithium Battery - df models drive & fly I-PEAK 6 Instructions D'utilisation

Storage control of Lithium battery

• This function is for charging/discharging batteries which are not used at once. This program is
designed for charging or discharging of batteries of specifi c original state. They are classifi ed
by types: 3.75V Lilo, 3.85V LiPo and 3.3V LiFe.
The program will begin to discharge if the original state of the battery exceeds the voltage level of
storage.
At this screen, you can set up the current and voltage of the battery pack. Charging and dis-
charging will make the batteries come to the voltage level of "storage" state.
This screen shows the real-time status charging. Press "Batt type/Stop" key once to stop the
charge process.

Discharging of Lithium battery

The value of discharge current on the left cannot exceed 1C, and the value on the right cannot
be under the voltage recommended by the manufacturer to avoid deep discharging. Press "Start/
Enter" for more than 3 seconds to start charging.
This shows the real-time status of discharging, you can press "Batt type/Stop" key to stop dis-
charging.
12
Charging current
Number of cells
Li3s
FAS
Elapsed time
LiPo
2.0A
Charging or discharging
Number of cells
Li3s 2.0A
STO 022:43
Elapsed time
LiPo
1.0A
www.df-models.com
Battery voltage
2.0A 12.59V
022:43 00682
Supplied capacity
STORAGE
11.1V(3S)
Current battery voltage
current
12.59V
00682
Supplied capacity
DISCHARGE
11.1V(3S)