Fast Charging Of Lithium Battery - df models drive & fly I-PEAK 6 Instructions D'utilisation

2. The value on the left side of the second lines sets the charge current. The value on the right
side of the second lines sets the battery pack's voltage. After setting current and voltage,
press "Start/Enter" for more than 3 seconds to start the process.
3. This displays the number of cells you set up and the processor detects. `
Top Line:
If both numbers are identical you can start charging by press "Start/Enter" button. If not, press
"Batt type/Stop" button to go back to previous screen to carefully check the number of cells of
the battery pack before going ahead.
4. This screen shows the real-time status during charge process. Press "Batt type/Stop" key
once to stop the charge process.

Fast charging of Lithium battery

Charging current will normally be reduced during the fi nal stage of the charging process. This
specifi c CV process will increase the fi nal charging current to end the charging process earlier.
The total charged capacity during fast charging will be a little less than during normal charging,
but charging time will be shortened accordingly.
1. Select this charge process by choosing LiPo FAST CHARGE from the main menu by pressing
the "Start/Enter" button. The display should look similar to this:
You can set up the charging current and voltage of the battery pack. Press "Start/Enter" key to
display voltage confi rmation.
2. Then press "Start/Enter" key again to confi rm and begin to charge. This screen shows the real-
time status of "fast charging". Press "Batt type/Stop" key once to stop the charge process.
S:3SER
CONFIRM
S = Number of cells selected by you in the previous screen.
R = Number of cells detected by the charger.
Number of cells Charging current
Li3s
BAL
Charging time
LiPo
2.0A
www.df-models.com
R:3SER
(ENTER)
Battery voltage
2.0A 12.59V
022:43 00682
Supplied capacity
FAST CHG
11.1V(3S)
11