Publicité
Les langues disponibles
Les langues disponibles
V4.0
9.
Turn on the power switch (#27).
10. For best results, use a five-step process: first grind, second grind, pre-polish,
polish and burnish.
a.
Check for and release gas build up after 12 hours. Check every 24 hours,
releasing gas and adding water as needed.
b.
First grind, where initial sharp edges are rounded, typically takes 7 to 10
days.
c.
To initiate second grind, when more smoothing occurs, remove and clean
contents and then replace and run for 2 to 3 days continuously.
d.
To initiate pre-polish, remove and clean contents and then replace and run
for week, checking every other day.
e.
Remove materials and rub with towel, dampened leather or polish to test
their shine. If not satisfactory, replace and run for another 24 hours.
f.
To initiate polish, remove and clean contents and then replace and run with
polishing compound (not included) for 5 to 7 days.
g.
Once complete, remove contents and clean. If materials have a film, replace
and add mixture of powdered soap (not included) and water and run for 4
days.
h.
If satisfied, remove materials and clean.
11. Hard materials may require more than a single process.
CARE & MAINTENANCE
CAUTION! Check tumbler regularly to ensure unit is running properly and not
overheating.
1.
Before the first use, and a once month thereafter, place a few drops of oil on the
driving shaft bearings (#1, 2, 3).
2.
Check the V-belt (#40) for tension before each use. It must be kept as loose as
possible without allowing it to slip on the pulley (#36).
3.
Make sure the exteriors of the rubber barrel (#12) are clean so that they do not
slip on the roller shafts (#4, 42). Wipe with a soapy cloth and then wipe clean with
a damp cloth and let dry thoroughly.
4.
Maintain the tool's labels and name plates. These carry important information. If
any are unreadable or missing, contact Princess Auto Ltd. for replacements.
Visit www.princessauto.com for more information
8980765
5
Publicité
