Bourgeat SATINE Notice D'utilisation page 6

y Advice :
- maintain stainless steel surfaces clean and dry. Ensure there is a sufficient flow of air.
- clean daily to remove scale, grease and any food residue. Corrosion can form under these layers by lack of air inlet.
- daily cleaning can be performed with a damp cloth. If necessary :
* use soapy water, cleaning products with low chloride content, javel-free detergents, window degreasers.
* remove hard stains with a non metallic brush (plastic material, natural bristles or stainless steel wool).
- do not scratch the surfaces with metals other than stainless steel, and more particularly, never use iron brushes.
- remove fresh rust stains with soft abrasive agents or fine emery cloth.
- for larger stains, use hot oxalic acid with a 2-3% concentration. If necessary, apply a treatment with nitric acid concen-
trated at 10%.
After treatment, wash thoroughly with water and wipe.
The use of acid is reserved to skilled persons and complying with regulations.
y Product to ban :
- Javel water and chlorine based products
- hydrochloric acid
- iron oxide abrasive powders.
y Tempered glass sneeze guard : unscrew the two nuts located on either side of the glass. Lift it while holding it with both hands.
Cleaning: clean manually using a grease-cutting product or washing-up liquid, or in the dishwasher.
y Carving plate : Do not clean in the dishwasher. The products used may tarnish the treated surface.
Cleaning: clean manually using a grease-cutting product (do some preliminary tests) or a washing-up liquid.
y Utensil holder slate : clean with a sponge and soapy water. Do not wash in dish-washer. To revive it, use food grade oil.
This equipment carries the recycling symbol in accordance with Directives 2002/95/CE and 2002/96/CE relating to Waste Electrical or Electronic
Equipment (DEEE or WEEE) At the end of its working life the equipment should be recycled in accordance with the regulations that are in force in
the country of its installation.
6