Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
BLIND
DISPLAY
LF 5
DISPLAY
LF 5
ZP 0
LF 5
APPROVAL CONFIRMITY
DISPLAY
LF 6
!
GRAVITY
*Introduce the gravity of your zone before doing the first calibration.
*Introduce the gravity of destination after doing the calibration.
*The value of the gravity will be denied if it is bigger than 9.83217 ( gravity of the pole) or inferior to 9.78031 ( gravity of the
equator).
Value of factory: 9.8035
42
LF 5
ZP 0 OFF
ZP 1 One division will not show being at zero
ZP 2 Two division will not show being at zero
ZP 3 Three divisions will not show being at zero
ZP 4 Four divisions will not show being at zero
ZP 5 Five divisions will not show being at zero
*This function is going to be blocked when UF-5 is in mode HOLD 1
*The value of factory is ZP 0
• Press the key
automatically.
• Use the key
ESC to exit from the configuration and go back to the menu LF4)
• Use the keys
to exit from the menu and the scale is going to start automatically.
LF 6
nonE Version not approved
DON'T MODIFY, IN NO WAY, THIS PARAMETER. IT MUST ALWAYS BE CONFIGURED AT
nonE.
The change of this parameter implies the blocking of some functionalities.
LF 7
DESCRIPTION AND SEQUENCE OF USE
DESCRIPTION AND SEQUENCE OF USE
to start or the key
to exit from the menu and the scale will start again
and the key
to select how many divisions will show when in zero ( press
,
and then the key
to continue with other adjustment or press the key
DESCRIPTION AND SEQUENCE OF USE
USER'S MANUAL ABD
EN
EN
Publicité
Table des Matières
