bora PI 11-000 Instructions De Montage Et D'utilisation page 49

... Installation
► Mount the toggles. Ensure that dimension 18,5 mm is maintained when the
knobs are in "0" position.
► If the two toggles are not at the same distance from the power
control sleeves, adjust the distance with the adjusting screw in
the toggle shaft, using the enclosed Allen wrench. Both
toggles must be at a distance of 18,5 mm from the respective
sleeve (see above diagram).
After installation, connect the cooktop to the control unit.
yellow/green earthing conductor to the tab q and then connect the two 8-pin
plugs of the cooktop to the socket section of the control unit, observing the colour
codes.
Cover
Power control
sleeve
Toggle
Allen
wrench
First connect the
13