bora PI 11-000 Instructions De Montage Et D'utilisation page 45

... Installation
Installation of the control unit in the front cover of the bottom kitchen
cabinet
upper side of worktop
worktop
cover
The four bores for the control unit must be made at the centre of the
cooktop.
Install a cable protection shelf below the control
the unit, provide an opening of 100 mm across the entire kitchen base
unit width.
Please note that it is not possible to install under-counter appliances below
the cooktop or the control unit.
Installation
■ The use of solid timber wall strips behind the built-in cooktop on the worktop is
permissible, provided the required minimum distances are maintained.
■ The use of plastic wall strips is not permissible.
■ Changes in the surface colour normally result from the effect of light.
37 90
37
unit. At the rear of
9