Briteq LDP ACCUSPOT 7TC Mode D'emploi page 8

ENGLISH
Remark: You can connect a JBS CA-8 remote controller to the master unit if you want to have more
control over the master/slave operation. You can also connect the JBS LEDCON-02 remote controller
Electrical installation for two or more units in DMX-mode:
You can control the LDP-ACCUSPOT by DMX in different ways, depending on your needs. You can go for a
wired solution (using cables), you can go for a completely wireless solution or you can gop for a combination
of both...
WIRELESS SOLUTION
 All projectors should be equipped with the optional "W-DMX module".
 Switch all projectors on.
 Put all projectors in the desired DMX-channel mode (see chapter HOW TO SETUP: option ChMd
)
 Set the desired DMX start address on all projectors, take in account the number of DMX channels
used by the selected DMX-channel mode! (see chapter HOW TO SETUP: option Addr )
 Synchronize all projectors with the wireless W-DMX transmitter (our Briteq
transmitter is 100% compatible): (see chapter HOW TO SETUP: option Udrt )
 Once this is done everything should work.
MIXED SOLUTION
 The first projector in the chain should be equipped with the optional "W-DMX module".
 Daisy chain all projectors using good quality balanced microphone/DMX cables.
 Switch all projectors on.
 Put all projectors in the desired DMX-channel mode (see chapter HOW TO SETUP: option ChMd
)
 Set the desired DMX start address on all projectors, take in account the number of DMX channels
used by the selected DMX-channel mode! (see chapter HOW TO SETUP: option Addr )
 Synchronize the first projector in the DMX-chain with the wireless W-DMX transmitter (our Briteq
"WT-DMXG4" transmitter is 100% compatible): (see chapter HOW TO SETUP: option Udrt )
 Once this is done, the first unit is controlled by wireless DMX and will pass the DMX-signal to the
other projectors via the wired DMX-chain.
BRITEQ
®
6/69
USER MANUAL
®
"WT-DMXG4"
LDP-ACCUSPOT 7TC
®