Briteq LDP ACCUSPOT 7TC Mode D'emploi page 13

ENGLISH
C. Connect the optional JBS CA-8 controller for more control:
The JBS CA-8 controller can only be used in standalone or master/slave mode. Connect the controller to
the JBS CA-8 input of the first unit (master). Now you can control all the connected units:
BUTTON
STANDBY
1.Synchronous strobe
in white color
2.The same color
FUNCTION
chase
3.Different color
strobe
Strobe
MODE
(LED OFF)
D. Connect an optional JBS LEDCON-02 controller for more control:
The JBS LEDCON-02 controller can only be used in standalone or master/slave mode. Connect the
controller to the DMX-input of the first unit (master). Make sure that the LDP-ACCUSPOT projectors are
all set to channel mode1 (Md 1). Now you can control all the connected units in 4 or 8channel mode.
Refer to the user manual of the JBS LEDCON-02 controller for more information and automatic
addressing.
E. Controlled by universal DMX-controller:
 Connect all units together. Refer to the chapter "Electrical installation for two or more units in DMX-
mode" to learn how to do this (don't forget to address all units properly!)
 Turn on the DMX controller.
Since each unit has its own DMX-address, you can control them individually. Remember that each unit
uses 4 or 6 DMX-channels as shown in the DMX chart below:
Channel modes 1 + 2 + 3 + 4:
Channel4 can have 4 different behaviors, depending on the channel mode (1,2,3 or 4) you selected.
BRITEQ
®
ACTIONS
To blackout all the fixtures
Select one of the Select one of the 12
different colors. different multi-channel
shows.
Color select Show select
(LED ON) (LED slow blinking)
11/69
USER MANUAL
Select one of the
different color fade
modes.
Chase select
(LED fast blinking)
LDP-ACCUSPOT 7TC