Briteq LDP ACCUSPOT 7TC Mode D'emploi page 12

ENGLISH
 Once the mode is selected, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to return to running mode.
"Led" Led Display
Display on: display is always on.
Display off: display is off when not used.
 Press the MENU button until the display shows "Led".
 Press the ENTER button.
 Use DOWN and UP buttons to select " on " (display always on) or "oFF " (display off when not used).
 Once the mode is selected, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to return to running mode.
"dISP" Display Inversion
Display inversion: display is readable when the unit is mounted upside down.
 Press the MENU button until the display show "dISP"
 Press the ENTER button, to toggle between normal and inversed display.
 Press the MENU button for about 2 seconds to return to running mode.
"teMP" Fixture Temperature
 Press the MENU button until the display shows "teMP".
 Press ENTER button, the display will show the temperature of the LEDs in the unit.
 To go back to the functions press the MENU button again.
If you want to go back to normal running mode: press the MENU button for about 2 seconds.
"FhrS" Fixture Hours
Used to show the number of working hours of the unit.
 Press the MENU button until "FhrS" is shown on the display.
 Press the ENTER button to show the number of working hours in the display.
 To go back to the functions press the MENU button again.
If you want to go back to normal running mode: press the MENU button for about 2 seconds.
"Ver " Software version:
Used to show the software version of the unit.
 Press the MENU button until "Ver "is shown on the display.
 Press the ENTER button to show the software version of the unit.
 To go back to the functions press the MENU button again.
If you want to go back to normal running mode: press the MENU button for about 2 seconds.
OPERATING INSTRUCTIONS
A. Standalone 1unit:
 Select one of the automatic modes or select a fixed color
 Select the static or sound control mode
 Don't forget to set the Blackout mode to 'NO Blackout' or nothing will happen.
 Refer to chapter HOW TO SETUP to learn how to make the previous settings.
Remark: You can connect a JBS CA-8 remote controller to the unit if you want to have more control.
B. Two or more units in master/slave setup:
 Connect 2 to maximum 16 units together. Refer to the chapter "electrical installation" to learn how to
do this.
 Set the slave mode for each projector: the first one must be set on Master and each slave projector
can be set to its specific slave mode (see chapter HOW TO SETUP the slave mode)
 Connect all units to the mains and put on some music. The units will start working automatically to the
rhythm of the music and show the internal chase programs.
 Don't forget to set the Blackout mode to 'NO Blackout' or nothing will happen.
Remark: You can connect a JBS CA-8 or JBS LEDCON-02 remote controller to the master unit if you
want to have more control over the master/slave operation.
BRITEQ
®
10/69
USER MANUAL
LDP-ACCUSPOT 7TC