AirSep Focus Manuel page 174

Focus™
[Read the Important Safety Rules section before operating this equipment.]
Power Supplies (Overview)
Focus can be powered in four different ways – the battery, AC power, DC power,
or an optional AirBelt. The Focus power supply functions both as an AC power
supply and a DC power supply.
(Refer to Connecting to Focus's Power Inlet section for specific
instructions regarding the connection of optional power sources.)
•
Battery: Two rechargeable batteries are supplied with Focus. Each
battery, when fully charged, supplies power to the Focus unit for up to
1½ hours. An audible alarm sounds when the battery power is getting
low. The alarm is discussed in the Audible Alarm and Indicator Lights
section of this manual. The 25% capacity LED will blink every half
second to indicate a low state of charge when the button is pressed.
During this condition, change to another battery or alternate power
source.
•
Battery Charging (Battery Charging section): To charge the battery,
connect the battery to either the power supply and a 100-240 volt, 50/60
Hz AC power socket, or connect the power supply to a DC power socket
in a car (boat, motor home, etc.). A discharged battery requires
approximately four hours to fully charge. It is recommended to recharge
the battery, even if only partially depleted, as often as possible.
•
Universal Power Supply
The AC power supply side of the universal power supply allows the
Focus unit to connect to a 100-240 volt, 50/60 Hz socket. The power
supply converts 100-240 volt AC to a DC voltage for the Focus unit to
operate while simultaneously recharging the Focus battery.
The DC power inlet on the universal power supply allows the Focus
unit to connect to a motor vehicle's 12-Volt DC socket for the Focus
unit to operate while simultaneously recharging Focus's battery.
•
Optional AirBelt: Focus can also be powered with AirBelt. AirBelt can
be worn around the waist. When fully charged, the battery supplies
power to Focus for up to 3½ hours. AirBelt connects to the Focus unit's
power inlet. It can only be recharged by connecting it to the AirBelt AC
power supply.
®
AirSep Corporation
MN172-1 rev. - 03/11
GB
GB-22