Elkron IR600FC Guide Rapide page 4

Learning procedure
The detector must be learnt by the control unit to transmit the signal if motion is detected. Proceed as follows to perform the
device learning procedure.
The detector may be learnt by the control unit only within three minutes from switch-on.
1. Remove the battery compartment lid and insert the three CR123A batteries (included).
2. Make sure that the tamper switch is open (released).
3. Make sure that the learn function has been activated on the control unit. Within three minutes from switch-on, hold
the function button pressed for 10 seconds and then release it when the blue LED and the illuminator blink once.
4. After having been leant by the control unit, the detector is automatically recorded in the system. Check the control
unit to check that the learning and registration procedure were performed correctly.
5. Once learnt by the control unit, if the detector connection is lost, the LED will blink once every 20 minutes to signal
the fault.
Detector installation
Surface installation:

1. Loosen the fixing screw and gently lift the cover, taking care not to lose the rubber
button over the tamper switch.
2. Perforate the hole arrangements on the base for fixing on a surface.
3. Using the two holes as template, drill the holes corresponding to the surface.
4. Insert the anchor bolts if the device is fixed to plaster or
bricks.
5. Screw the base into the anchor bolts.
6. Reposition the cover onto the base.
Corner installation:

1. Perforate the two arrangements for holes on the corner bracket.
2. Using the two holes as template, drill the holes corresponding to the surface.
3. Insert the anchor bolts if the device is fixed to plaster or bricks.
4. Screw the bracket into the anchor bolts.
5. Fasten the detector to the bracket.
Hereby, URMET S.p.A. declares that the radio equipment type: INDOOR INFRARED DETECTOR WITH CAMERA IR600FC/N is
in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet
address: www.elkron.com.
CLICK ON THE FOLLOWING LINK OF THE ELKRON SITE TO ACCESS THE PRODUCT TECHNICAL SHEET AND
DOWNLOAD THE COMPLETE MANUAL:
DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 4 July 2012 on waste electrical and
electronic equipment (WEEE).
The symbol of the crossed-out wheeled bin on the product or on its packaging indicates that this product must not be
disposed of with your other household waste.
Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point
for the recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste
equipment at the time of disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects
human health and the environment.
For more information about where you can drop off your waste equipment for recycling, please contact your local city office,
your household waste disposal service or the shop where you purchased the product.
ELKRON
Tel. +39 011.3986711 - Fax +39 011.3986703
SIMPLIFIED EU DECLARATION OF CONFORMITY
www.elkron.com
– mail to: info@elkron.it
Hole provisions for fixing on
surface (x 2)
Arrangement for holes for
corner fixing (x 2)
ELKRON is a trademark of URMET S.p.A.
Via Bologna 188/C – 10154 Turin (TO) Italy
www.urmet.com
MADE IN TAIWAN