Hama 00210576 Mode D'emploi page 3

Note – Power Delivery /
QC 3.0, 2.0
• Plug & go: No manual setup necessary, just
connect and start:
Voltage and power are automatically
configured by Power Delivery/QC 3.0, 2.0.
• For efficient and optimised charging, the
Power Delivery (PD)/QC 3.0, 2.0 function must
be supported by your terminal device.
• With the large quantity of PD/QC-enabled
terminal devices with different firmware
versions, it can happen that the function is
not fully supported.
Unless the operating instructions for the devices
you want to charge explicitly inform you otherwise,
proceed as follows:
• Connect your terminal device to the USB-C
charging socket using a suitable USB-C cable.
• Connect the charger to the car socket of the
vehicle electrical system.
• Charging progress is displayed on your terminal
device.
• Disconnect the terminal device from the charger if
you want to interrupt charging or if the terminal
device is fully charged.
• Then disconnect the charger from the power
supply.
When charging batteries built into a device, pay
attention to the maximum charging time for the
batteries.
Note – Car battery
With some vehicles, it can happen that power
continues to be supplied even though the ignition
has been switched off. Therefore, when not using
the product, disconnect it from the power supply
to protect your car battery from discharge.
5. Care and Maintenance
• Only use dry, soft cloths for cleaning.
Note
Disconnect the device from the power supply
before cleaning or if it will not be used for a
long period of time.
6. Technical specifications
Car Charger
Vehicle electrical system
voltage
Max. output voltage/current
Total output power
Ambient temperature
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
the product or from failure to observe the operating
instructions and/or safety notes.
8. Recycling Information
Note on environmental protection:
After the implementation of the European
Directive 2012/19/EU and 2006/66/EU in
the national legal system, the following
applies: Electric and electronic devices as
well as batteries must not be disposed of with
household waste. Consumers are obliged by law to
return electrical and electronic devices as well as
batteries at the end of their service lives to the public
collecting points set up for this purpose or point of
sale. Details to this are defined by the national law
of the respective country. This symbol on the product,
the instruction manual or the package indicates that
a product is subject to these regulations. By
recycling, reusing the materials or other forms of
utilising old devices/Batteries, you are making an
important contribution to protecting our
environment.
12 V, 24 V
5V 3A
9V 2,77A
PPS:
3,3-5.9V 3,0A
3,3-11V 2,25A
25 W max.
0°C – 40°C
3