Leica PINMASTER Notice D'utilisation page 31

MAINTENANCE/CLEANING
Your Leica Pinmaster does not require special care.
Any large dirt particles, such as sand, should be
removed with a soft brush or be blown off. Fingerprints
etc. on the lens or eyepiece can be can be cleaned off
the lenses by first moistening them with a damp cloth
and then wiping with a soft, clean chamois leather or
lint-free cloth.
Important:
Do not exert excessive pressure when wiping heavily
soiled lens surfaces. Although the coating is highly
resistant to abrasion, sand or salt crystals can still
damage it. The housing should be cleaned only with a
dampleather. Using dry cloths can lead to an
electrostatic build-up. Alcohol and other chemical
solvents must not be used to clean the optics or the
housing. As well as its type designation, each Leica
Pinmaster has its "personal" serial number. Make a
note of this number in your documents for security.
Attention:
Do not open the main body under any circumstance!
Spare parts
If you should require any spare parts for your
Leica Pinmaster, e.g. eyepiece cup or carrying cord,
please contact our Customer Service department
(address, see p. 31) or the Leica distributor in
your country (see Warranty Card for addresses).
EN
27