To Transport The Product With A Vehicle; Storage; To Put The Product In Storage; Disposal - Meec tools 009876 Traduction Des Instructions D'origine

5
Hold the transport handle and tilt the product until it
balances on its wheels to move the product.
6.2 To transport the product with a
vehicle
Warning! Be aware of the weight of the product. Be
careful when you move the product.
1
Stop the product. Refer to "4.8 To stop the product"
on page 37.
2
Disconnect the power plug from the power source
and roll up the power cord on the power cord holder.
3
Disconnect the water hose from the water inlet on
the product.
4
Make sure that the lid on the detergent container is
installed.
5
Make sure that product cannot move around in or on
the vehicle when you transport the product.
Caution! Vibrations and shocks can cause damage to
the product. Use applicable transport protection when you
transport the product with a vehicle.
7

Storage

7.1 To put the product in storage

Warning! Be aware of the weight of the product. Be
careful when you move the product.
Caution! Do not expose the product to frost. Frost can
cause damage to the product. Always keep the product in a
frost-free environment.
1
Stop the product. Refer to "4.8 To stop the product"
on page 37.
2
Disconnect the power plug from the power source
and roll up the power cord on the power cord holder.
3
Close the valve in the tap.
Note! If you use an open water source, remove the suction
hose from the open water source.
4
Disconnect the water hose from the water inlet on
the product.
39
Warning! Hot water can flow out when you discon-
nect the water hose after operation.
5
Hold the spray gun firmly with both hands and push
in the trigger to release the pressure in the system.
Keep the trigger pushed in until no water comes out.
Warning! Do not point the spray gun in a direction
where the water jet can cause injury or damage.
6
Remove the spray head from the spray gun and put
the spray head in the spray head holder. Make sure
that the nozzle on the spray head is in the direction of
the spray head guard.
7
Disconnect the high-pressure hose from the spray
gun and put the spray gun in the spray gun holder.
Warning! Hot water can flow out when you discon-
nect the high-pressure hose after operation.
8
Roll up the high-pressure hose on the hose reel and
put the quick coupling in its holder.
9
Put the product on a stable and level surface in a
dust-free and frost-free storage that has an ambient
temperature of 10–30°C.
Caution! Do not expose the product to frost. Frost can
cause damage to the product.
Note! If it is possible, put the product in its packaging.
8

Disposal

8.1 To discard the product

● Make sure that you follow local regulations when you
discard the product. Do not burn the product.
2022_001