Maintenance; To Clean The Base Unit; To Clean The Filter; To Clean The Spray Head Nozzle - Meec tools 009876 Traduction Des Instructions D'origine

Warning! Follow the safety instructions from the
manufacturer of the detergent.
Caution! Only use detergents that are intended for
high-pressure washers.
4
Carefully put the detergent container in the holder on
the product.
5
Put the detergent suction hose with filter in the
detergent container and install the lid on the
detergent container.
Note! The detergent suction hose is attached to the lid.
6
Turn the adjustment knob for detergent clockwise to
adjust the amount of detergent. (Figure 12)
7
Point the spray gun at the surface you want to apply
detergent on.
8
Disengage the trigger lockout. Refer to "4.4 To
disengage and engage the trigger lockout" on page
36.
9
Push in the trigger and move the spray gun over the
surface to apply detergent. Keep the trigger pushed
in until you have applied the necessary amount of
detergent.
Caution! Refer to the instructions and safety instruc-
tions for the detergent.
5

Maintenance

5.1 To clean the base unit

Warning! Always stop the product, disconnect the
power plug, and release the pressure in the system before
you clean or do maintenance on the product.
Warning! Do not immerse the product in water or
other liquid. Risk of electrical shock.
● Clean the base unit with a damp cloth.

5.2 To clean the filter

Warning! Always stop the product, disconnect the
power plug, and release the pressure in the system before
you clean or do maintenance on the product.
2022_001
1
Stop the product. Refer to "4.8 To stop the product"
on page 37.
2
Disconnect the water hose from the water inlet on
the product.
3
Carefully pull out the filter in the water inlet. Use
flat-nose pliers.
4
Rinse the filter in clean hot water. (Figure 13)
5
Install the filter in the water inlet.

5.3 To clean the spray head nozzle

Warning! Always stop the product, disconnect the
power plug, and release the pressure in the system before
you clean or do maintenance on the product.
1
Stop the product. Refer to "4.8 To stop the product"
on page 37.
2
Remove the spray head from the spray gun.
3
Use the nozzle cleaning tool (included with the
product) to remove unwanted materials from the
nozzle on the spray head. (Figure 14)
4
Rinse the nozzle on the spray head.
6

Transport

6.1 To transport the product by hand

Warning! Be aware of the weight of the product. Be
careful when you move the product.
1
Stop the product. Refer to "4.8 To stop the product"
on page 37.
2
Disconnect the power plug from the power source
and roll up the power cord on the power cord holder.
3
Disconnect the water hose from the water inlet on
the product.
4
Push in the release button for the transport handle
and pull up the transport handle until you hear a click
sound.
Note! Use transport protection if it is necessary.
38