To Connect The Product To A Water Source; To Start The Product; To Disengage And Engage The Trigger Lockout; To Remove Air From The System - Meec tools 009876 Traduction Des Instructions D'origine

Caution! The product can become damaged if it is
not in an upright position.
2
Make sure that the power switch is in the "OFF/0"
position. (Figure 8)
3
Connect the power plug to an earthed power outlet.
Warning! Do not touch the power plug with wet
hands or other wet parts of your body.
Caution! Do not operate the product before you have
connected it to a water source. The high-pressure pump can
become damaged if you operate the product without water.
4.2 To connect the product to a water
source
The product can use water from either a tap or an open
water source, for example a pond or a barrel.
4.2.1 To use water from a tap
1
Put the product in an upright position on a level and
stable surface.
Caution! The product can become damaged if it is
not in an upright position.
2
Connect the water hose to the water inlet on the
product. (Figure 7)
3
Connect the water hose to the tap.
4
Make sure that the hose is fully connected.
5
Open the valve in the tap and make sure that there is
no leakage.
Caution! The water temperature must not be higher
than 40°C.
6
Remove air from the system. Refer to "4.5 To remove
air from the system" on page 36.
Caution! Unwanted materials in the water can cause
damage to the high-pressure pump and the accessories.
Make sure that the water is clean.
7
Put the product in an upright position on a level and
stable surface.
2022_001
Caution! The product can become damaged if it is
not in an upright position.
8
Fill the suction hose with water.
Note! The suction hose must have a check valve.
9
Connect the suction hose to the water inlet on the
product.
10
Put the other end of the suction hose in the open
water source.
11
Remove air from the system. Refer to "4.5 To remove
air from the system" on page 36.

4.3 To start the product

1
Connect the product to a power source and a water
source. Refer to "4.1 To connect the product to a
power source" on page 35 and "4.2 To connect the
product to a water source" on page 36.
2
Turn the power switch to the "ON/I" position to start
the product. (Figure 9)
Caution! Make sure that the valve in the tap is open
before you start the product.
3
Remove air from the system. Refer to "4.5 To remove
air from the system" on page 36.
4.4 To disengage and engage the
trigger lockout
The trigger can be locked to prevent accidental operation of
the spray gun.
● Push the trigger lockout button to the locked position (A)
to engage the trigger lockout. (Figure 10)
● Push the trigger lockout button to the unlocked position
(B) to disengage the trigger lockout.

4.5 To remove air from the system

Warning! Use safety glasses and applicable personal
safety equipment.
Warning! Do not point the spray gun in a direction
where the water jet can cause injury or damage.
Caution! Only operate the product in an upright
position on a level and stable surface. (Figure 11)
36