After Finishing The Work; Transport - Meec tools 009874 Mode D'emploi

EN
DURING A PAUSE IN THE WORK
1. Release the trigger.
2. Lock the spray gun with the catch.
3. Put the spray gun with the spray head in
the storage position.
4. Switch off the high-pressure washer with
the power switch if it is not going to be
used for 5 minutes or more.

AFTER FINISHING THE WORK

1. Release the trigger.
2. Switch off the high-pressure washer with
the power switch.
3. Pull out the plug.
4. Release the pressure from the high-
pressure washer before removing the
pressure hose from the spray gun or the
washer.
5. Press the trigger to release any residual
pressure in the system.
6. Release the trigger.
7. Lock the spray gun with the catch.
8. Disconnect the water supply from the
high-pressure washer.
NOTE:
Hot water can run out after using the high-
pressure washer when the supply hose or
high-pressure hose are disconnected.
MAINTENANCE

TRANSPORT

IMPORTANT:
• Risk of personal injury and/or material
damage.
40
• Take the weight of the high-pressure
washer into consideration when
transporting.
Transporting by hand
• Switch off the high-pressure washer,
disconnect the water supply and pull out
the plug.
• Pull out the transport handle until it locks
in place with an audible click. Use
transport protection where appropriate.
• Always hold the high-pressure washer by
the transport handle.
Transport with vehicle
• Put the lid on the detergent bottle if the
high-pressure washer is to lie flat when
transported.
• Tilt the high-pressure washer towards you
so that it balances on the wheels and
move it by using the transport handle.
• Protect the high-pressure washer from
vibrations and knocks during
transportation.
• Make sure that the high-pressure washer
cannot move or tip over when it is
transported.
Storage
IMPORTANT:
• Risk of personal injury and/or material
damage.
• Take the weight of the high-pressure
washer into consideration when putting
it away.
1. Place the high-pressure washer on a level,
stable surface.
2. Remove the spray head from the spray gun.
3. Press the release button on the spray gun
and pull the high-pressure hose off the
spray gun.