To Operate The Product; To Change Spray Mode; To Stop The Product; To Use Detergents With The Product - Meec tools 009876 Traduction Des Instructions D'origine

1
Start the product. Refer to "4.3 To start the product"
on page 36.
2
Remove the spray gun from the spray gun holder.
3
Disengage the trigger lockout. Refer to "4.4 To
disengage and engage the trigger lockout" on page
36.
4
Hold the spray gun firmly with both hands and push
in the trigger. Water starts to come out from the spray
head. Keep the trigger pushed in until water without
air bubbles comes out of the spray head.
Warning! Do not point the spray gun in a direction
where the water jet can cause injury or damage.
Caution! Do not operate the product for more than
2 minutes without water. The high-pressure pump can be-
come damaged if you operate the product without water.
5
Release the trigger and engage the trigger lockout.
6
Turn the power switch to the "OFF/0" position.
(Figure 8)

4.6 To operate the product

Warning! Use safety glasses and applicable personal
safety equipment.
Warning! Do not point the spray gun in a direction
where the water jet can cause injury or damage.
Warning! Always engage the trigger lockout before
you take a pause from operation.
Warning! Always turn the power switch to the
"OFF/0" position if you are away from the product for more
than 5 minutes.
1
Start the product. Refer to "4.3 To start the product"
on page 36.
2
Point the spray gun at the surface you want to clean.
3
Disengage the trigger lockout. Refer to "4.4 To
disengage and engage the trigger lockout" on page
36.
4
Hold the spray gun firmly with both hands and push
in the trigger. Keep the trigger pushed in and move
37
the spray head over the surface until the surface is
clean.
Caution! Hold the nozzle of the spray head at least
30 cm away from painted surfaces when you operate the
product.
Note! The spray gun operates until you release the trigger.

4.7 To change spray mode

The spray head has 3 spray modes, fan shape mode (A), line
shape mode (B), and foam mode (C). (Figure 15)
● To change spray mode, turn the top of the spray head
until the arrow is at the required mode.

4.8 To stop the product

1
Release the trigger on the spray gun and engage the
trigger lockout. Refer to "4.4 To disengage and
engage the trigger lockout" on page 36.
2
Put the spray gun in the spray gun holder.
3
Turn the power switch to the "OFF/0" position to stop
the product. (Figure 8)
Warning! There is still pressure in the system after
you have stopped the product.
4.9 To use detergents with the
product
Warning! Follow the safety instructions from the
manufacturer of the detergent.
Caution! Only use accessories and parts that are
approved by the manufacturer of the product.
Note! Detergent can only be used when the product is in
low pressure mode.
1
Remove the lid and the detergent suction hose with
filter from the detergent container.
Note! The detergent suction hose is attached to the lid.
2
Carefully pull out the detergent container from the
product.
3
Fill the detergent container with detergent.
2022_001