Silverline 441563 Mode D'emploi page 8

441563
Electrical Safety
The wires in this product are coloured:
Blue Neutral
Brown Live
Green & Yellow Earth
• This appliance must be protected by a suitable fuse.
• To prevent fire or shock hazard, do not expose this product to
rain, water or moisture.
• There are no user serviceable parts inside except those
referred to in this manual.
• Always refer servicing to qualified service personnel. Never
remove any part of the casing unless qualified to do so; this
unit contains dangerous voltages.
• Use of a residual current device will reduce the risk of
electric shock.
Dangerous environment
• Do not use power tools in damp or wet conditions, or expose
them to rain. Provide adequate surrounding work space
and keep area well lit. Do not use power tools where there
is a risk of explosion or fire from combustible material,
flammable liquids, flammable gases, or dust of an explosive
nature. When using power tools avoid contact with any
earthed items such as pipes, radiators, cookers, refrigerators,
metal baths and taps.
Protect yourself from vibration
• Hand held power tools may produce vibration. Vibration can
cause disease. Gloves to keep the operator warm may help
to maintain good blood circulation in the fingers. Hand held
tools should not be used for long periods without a break.
Maintain your power tool
• Ensure all ventilation holes are kept clear at all times.
Overheating and fire may otherwise result.
Always Disconnect
• Before changing fittings or accessories, always ensure that
your tool is disconnected from the power source.
Switch off before connecting
• Ensure that the power tool is switched off before connecting
to the power source. If the power tool stops unexpectedly,
turn the power switch to off.
Do not abuse the power cord
• Be sure your cable or extension cable is in good condition.
Always have a damaged cable or extension cable replaced
at an authorised service centre before using it. Never yank or
pull the cable to disconnect it from the power socket. Never
carry your tool by its cable. Keep the cable away from damp,
heat, oil, solvents and sharp edges.
Do not leave the tool running unattended
• Always wait until your tool has completely stopped
functioning, and has been unplugged, before leaving it.
Product Familiarisation
1 Upper blade housing
2 Upper cover knob
3 Blade guard
4 Blade guide
5 Blade
6 Table aligning screw
7 Lower cover knob
8 Lower blade housing
9 Sawdust ejection port
10 On/off switch
11 Zero stop set screw
12 Blade tension adjustment knob
13 Tracking adjustment knob
14 Blade guard adjusting knob
15 Work table
16 Table lock handle
17 Angle guide
18 Tilt scale
19 Mitre gauge
20 Fence
www.silverlinetools.com
Bandsaw
5