Télécharger Imprimer la page

Parkside PTPU 1500 A1 Consignes D'utilisation Et De Sécurité / Traduction Du Mode D'emploi D'origine page 10

Pompe pour bassin

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
If there is a risk of flooding, mount the plug connections in an area
which cannot flood.
RISK OF ELECTRIC SHOCK:
Make sure that the mains voltage matches the specifications on the
type plate.
Carry out the electrical installation in accordance with the national
regulations.
Before each use, check the device mains cable and mains plug
for damage. Defective mains cables must not be repaired, instead
they must be replaced with new ones. Have any damage to your
device repaired by an authorised specialist.
Do not use the mains cable to unplug the mains plug from the
socket. Protect the mains cable from heat, oil and sharp edges.
Do not carry or fix the device using the mains cable.
Only use extension cables which are splashproof and intended for
outdoor use. Always fully unroll a cable reel before use. Check the
cable for damage.
Unplug the mains plug from the socket before carrying out any
work on the device, if there are leaks in the water system and
when not being used.
Extension cables must not have a smaller cross-section than rubber
hose lines marked with H07RN8-F. The cable length must be 10 m.
The strand cross section of the extension cable must be at least
2.5 mm².
ATTENTION! NOT SUITABLE FOR DRINKING WATER
z Before using the device
Prevent the pump from
Ensure that the electrical connection is 230 V~ 50 Hz.
Check that the electrical socket is in good condition and that it is sufficiently fused (at least 6 A,
RCD switch).
Ensure there is no way that moisture or water can reach the mains connection. There is a risk of
electric shock.
NOTE: Ensure that the power cable forms a loop below the mains plug, in order to prevent water
running into the plug via the cable.
z Using the device
Check whether the position for the pump
surface before you use it. For smooth supporting surfaces, you can use the suction pads
underside of the pump
Depending on the application, connect the right hose with the pump
Make sure that the hose connections are tight. If necessary, use hose clamps (not included in the
scope of delivery). Select either the 13 mm
10
GB/IE/NI/CY/MT
running dry. Failure to do so will void any warranty and liability claims.
1
is secure and fix the pump
1
to do this.
1
6
or 16 mm
nozzle connector to fit the hose diameter.
7
onto the supporting
1
on the
3
.
1

Publicité

loading